|
|
|
#1
12-05-2004, 10:15 AM
|
|||
|
|||
steering mod ( tight turns ) question???
I've read several threads on adding 3.3k resistors between servo and main board to mod the steering. I've also seen many complaints about servo chatter caused by the servo trying to center the wheels. The other thing I've noticed is everyone mentioning the fact that you must turn down the steering sensitivity for it to work.
My question is this, has anyone tried or considered using smaller resistors like 2.2k ?? Thanks for the time all!!!
__________________
Yellow Skyline, Tiny RC CF Deck, V2 board, Tight Turns, GPM Suspension, CF Drive Shaft, Nuke 130 Motor, 2 or 3 cell lithium, Aluminum Rims, 18 awg Wiring, Wheel Shims, 2.0 Open Bearings, Deans Connectors, 2.5 Sealed Bearings 
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| steering mod ( tight turns ) question??? | nobel12 | General XMOD Tutorials | 0 | 12-04-2004 06:34 PM |
| Screws breaking off at steering knuckles. | bcjet | Beginner Questions | 10 | 10-31-2004 06:09 AM |
Linear Mode
