pro pulse speed controller

[c1v1c]

I just want to noe that if i use this http://www.atomicmods.com/ProductInf...roductid=13366
do i need anything else with it to make it work except for the motor and the battery??

ty

[librarianliam]

i think you would need the receiver also...
http://www.atomicmods.com/ProductInf...roductid=13367

[sweetvette]

thats the part of the esc that controls spped, and it would not work with xmods electronics. You would have to get all propulse electronics for it to work, wich might not be a bad i dea for a project.

[c1v1c]

Originally Posted by sweetvette

thats the part of the esc that controls spped, and it would not work with xmods electronics. You would have to get all propulse electronics for it to work, wich might not be a bad i dea for a project.

Thats wut i was thinking about but i have no clue of wut a pro pulse had like electronic parts.

[Numbchux]

just go full-out hobby grade. go to Tower Hobbies, or a local shop, and buy a full setup (like the Futaba one I have in my crawler). that's be much easier than trying to use anything from a propulse

[modman54935]

Originally Posted by c1v1c

I just want to noe that if i use this http://www.atomicmods.com/ProductInf...roductid=13366
do i need anything else with it to make it work except for the motor and the battery??

ty

that just controls two different version.. there is the street version, and race verson.. there is a lil black knob u slide back and forth to change it.. the street version goes a lil slower then the race verson but the race version you cant go into reverse with

[RedSXmodder]

Junk-mod-er on XMW is doing it. Its like, a scaled down version (same size, not as powerful) of a brushless Xmod. Its still really cool and is probably alot of fun to drive.

Correct me if I'm wrong sweed...

Later,
RedSXmodder

[c1v1c]

hey numbchux i chek on my local hobbie store and theres a futaba mc230cr and the novak xrs. Ithink i'll get the futaba because its the cheaper one but those can run a 130can motor right?