gen 1 tight turns

[BART]

Does anyone (Sweed??? Tex??? Bondo??? ) know the value of the resistor used in the tight turns mod for a gen 1? I'm not paying some online company to pack a resistor in a box and over inflate the price for me. Please dont respond with "I think its" please. I guess i would also need to know which 2 servo wires said resistor is hooked to.....Thanks.

[XmodDad]

Originally Posted by ZX9RBART

Does anyone (Sweed??? Tex??? Bondo??? ) know the value of the resistor used in the tight turns mod for a gen 1? I'm not paying some online company to pack a resistor in a box and over inflate the price for me. Please dont respond with "I think its" please. I guess i would also need to know which 2 servo wires said resistor is hooked to.....Thanks.

3.3k ohm

[BART]

So which 2 servo wires does it connect to?

[c1v1c]

two extremety one u leave the center one alone

[BART]

Originally Posted by c1v1c

two extremety one u leave the center one alone

[123Vette]

ok nice i need that, hey would rs carry these restitors? and how would i tell the value cuz i have some and i dont no what they r =/

[BART]

Originally Posted by 123Vette

ok nice i need that, hey would rs carry these restitors? and how would i tell the value cuz i have some and i dont no what they r =/

It should be stamped on the resistor...if not use an ohm meter.

[123Vette]

ok but im pretty sure i dont have a ohm meter

[skylinedriver]

I'm using 2.2k ohm 1/4 watt resistors in my Skyline. They're a bit smaller and easier to pack in behind the servo.

[meme405]

Originally Posted by skylinedriver

I'm using 2.2k ohm 1/4 watt resistors in my Skyline. They're a bit smaller and easier to pack in behind the servo.

But they wouldnt make the same difference...

I dont have an ohm meter either, but you can ask the person and they can tell you...or it should say somewhere on the package or maybe even on the resistor itslef...

[skylinedriver]

Originally Posted by meme405

But they wouldnt make the same difference...

I dont have an ohm meter either, but you can ask the person and they can tell you...or it should say somewhere on the package or maybe even on the resistor itslef...

It should make no difference. it should be printed right on the package. I like the 2.2K ohm because of the size.

[c1v1c]

I just came home from rs and the resistors package, there was the number of ohm behind the box but there was so much and all the resistors looked the same...i have no clue how to figure it out wich one are the 3.3k ohm?

[mustang-04]

Originally Posted by c1v1c

I just came home from rs and the resistors package, there was the number of ohm behind the box but there was so much and all the resistors looked the same...i have no clue how to figure it out wich one are the 3.3k ohm?

you need the ones that are cloered orange, orange, red, gold... these are 3.3

ive even installed a couple with the 4.7k resistors, they are yellow, violet, red, gold.



http://www.webcalc.net/calc/0231.php

[c1v1c]

kk thx but im too lazy to go back there lol...

Just found a good tut here http://www.geocities.com/cjoe8090/ti..._overview.html