Hs-55 servo swap evo?

[fieldfairy2]

I searched but didn't find my answer.

I am going to try to put a hs-55 servo in the evo car chassis to replace the old one. I know how to mount it and everything but i need to know the wire setup/diagram? basically where do i solder which wires were? i know the evo has 5 wires, black and white(seperatly) then i think it is white, orange and black.
The hs-55 has yellow orange and black sticking out of it.

Any one know the wire diagram? or where to solder each wire> or the electrical side to installing the servo?

thanks,
fieldfairy2