help

[deckerz]

ok so i got it all working again except motor, see i missed solder on stacking fets a there is a thin layer of solder on neg terminal. i cant get it off so should i do direct port?

[c1v1c]

If you want to take some solder off, Buy some de-solder braid at RS. It only cost a few bucks.

[deckerz]

Originally Posted by c1v1c

If you want to take some solder off, Buy some de-solder braid at RS. It only cost a few bucks.

cant, no radioshack in uk.

[XMDrifter]

just order some from somewhere. it's not real expensive

[deckerz]

yeah i know but iv read somewhere if you tin the motor wires ti the board it gives a cleaner currant?

[XMDrifter]

you have to directly solder the motor wires to the terminals for that to work.

[deckerz]

yeah thats what im saying, should i just do that?

[rsx racer]

Yeah, it improves performance but you'll want to make sure the solder isn't touching anything else that may cause a short.

[deckerz]

ok thanks, i did it with my evo board i put in gen1 and it went faster.
but yeh i know what you meen because the terminal is so close to the FETs.