Help troubleshoot

[r3ap3r03]

hi, yea i doing some small mods to help increase overall performance to my gen1, i tried my luck at 3 modifications : the on/off switch bypass that was successful, upgraded batt and motor wire to 18g that was successful also and i tried the resister tight turns which is wut im having problems with.... when i put the batts in and turn the remote on the servo turns all they way to the left and i cant move thought the remote. i pretty sure the resisters arnt exactly 3.3k but they should be pretty close

does anyone kno a way that i can fix this?....
thanks for the help

[Action B]

Originally Posted by r3ap3r03

hi, yea i doing some small mods to help increase overall performance to my gen1, i tried my luck at 3 modifications : the on/off switch bypass that was successful, upgraded batt and motor wire to 18g that was successful also and i tried the resister tight turns which is wut im having problems with.... when i put the batts in and turn the remote on the servo turns all they way to the left and i cant move thought the remote. i pretty sure the resisters arnt exactly 3.3k but they should be pretty close

does anyone kno a way that i can fix this?....
thanks for the help

Start by checking for continuity between the board and the servo itself. This makes sure that you have a good connection. The one side lock usually happens to me if I have pulled a wire off the board or servo accidentally.

Get back to us once you check that.

[Xmodman30]

00000

[mycrors4]

Originally Posted by Xmodman30

00000

umm.. can someone explain this? cause its too short to be binary code lol

[Xmodman30]

Originally Posted by mycrors4

umm.. can someone explain this? cause its too short to be binary code lol

I was just testing too see if i could post but i am a new member. I couldnt find out how to delete it after I posted?

[mr.hotrod]

and you couldnt try something pertinant... like an answer to the problem or a constructive comment?

[r3ap3r03]

Originally Posted by Action B

Start by checking for continuity between the board and the servo itself. This makes sure that you have a good connection. The one side lock usually happens to me if I have pulled a wire off the board or servo accidentally.

Get back to us once you check that.

Hello again alright so i checked the continuity and was able to figure out the problem, thanks you very much....

Now i seem to have a problem with what i be leave is now a range problem because after my car get about 1 foot away from the remote it will just accel for one sec then stop for another sec and accel for a sec ect... and thats with me having it on full throttle