#3
|
|||
|
|||
Yes it is safe to run xmods without bearings but make sure you have ur yellow bushings in or else it will noy run correctly and u might screw up your care. But in the near futur I recommend you get bearings because I have heard that if you run your xmod too long without bearings the the hoes where the bearing are supposed to go will get bigger and then thenbearings will not fit properley. Thanks. Hope this helps
__________________
350z and NSX 350z/ stage2 drift motor... NSX/Lithium Ions, Stage 2 Blue motor, 18g wire, suspension kit, and tireupgarde. |
#6
|
|||
|
|||
Well yea u can run it without bushings but like o impact u can screw up ur car. I suggest you dont buy the radioshack bearings becasue as you know they are $20.00... Well I suggest you get some bearings off ebay or something. And yes the bearings will replace the stock yellow bushings..
__________________
350z and NSX 350z/ stage2 drift motor... NSX/Lithium Ions, Stage 2 Blue motor, 18g wire, suspension kit, and tireupgarde. |
#8
|
||||
|
||||
you should get the bearing up grade as soon as posible the bushings make the opening bigger and the bearing wont fit right
__________________
-EVO 2005 Mustang locked rear diff stage 2 motor and springs 2300 mAh's power Body lowered over chassis -Custom 04 wide body mustang-Work In Progress http://excoboard.com/exco/index.php?boardid=15437 C-A-N-A-D-I-A-N-R-A-C-E-R |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|