![]() |
#3
|
||||
|
||||
![]() 1. look at ur car from the brake lights w/ the body off
2. on the left battery pack disconnect the red wire 3. solder the black wire from ur new pack in the red wires place 4. solder the two red wires u should hav hanging there to each other (put some heat shrink over the joint to avoid a short) heat shrink= the little black tabs that were on ur xmods axles when u first opened the box u can do it that way or solder the red wire from ur added batt pack straight to the board instead of joining the two red wires if this is horribly confusing go to the how-to page in here www.mightymods.com
__________________
I've got 2 working XMODS and enough parts to make another 4, a Traxxas TMAXX w/3.3 race motor, and 2Nissan 240SX's. |
#8
|
||||
|
||||
![]() Quote:
![]() ![]() ![]()
__________________
I've got 2 working XMODS and enough parts to make another 4, a Traxxas TMAXX w/3.3 race motor, and 2Nissan 240SX's. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
JSHWAA'S H-BRIDGE INSTALL TUTORIAL w/desoldering how-to | Jshwaa | General XMOD Tutorials | 5 | 11-01-2004 11:05 AM |