Hand winding motors.

[Lowrideit]

After reading up some about Hand wount? motors... I thought, why dont I try it,... So I tore? apart a S1 motor, and I was reading about how many winds,
A stock can take around 47 correct?
I wanna do 50 winds too be safe?
Well, when you say winds... You mean, like that many times around the 3 things... Like, you take the arm outta the can, And keep mags in. and then you get your wire stuff lose, now you have those 3 mag looken things, that keep the wires in place, I wind that 50 times, to each of them correct??

[2wdpancar]

Check this tut out man...
http://xmodsforum.co.uk/showthread.php?t=2194

Are you gunna use it in a gen1 or EVO?
Ge1n you shouldn't go any lower than 47T, but at 47t don't gear it over 9 teeth..the fets can go...

[Lowrideit]

Evo deffently, thanks for the tut blt, your the one who influcned me on this one, haha,
So whats safe for evos?

[2wdpancar]

37T max.
Don't go any lower than that.
If you use the 12t gear, wind 40turns...to be on the safe side

[Lowrideit]

well, im going with 8:25 gears, I want alot of tourge, not so much top speed.

[Nissanshift350]

So blt ur saying I can go as low as 37 winds on a stock fet evo chassis?

[2wdpancar]

Originally Posted by Nissanshift350

So blt ur saying I can go as low as 37 winds on a stock fet evo chassis?

Exactly my friend.
If you use torque gears, I take you'll be drifting.
Then you should still use around 40 turns.
37 is the dead limit.

[Lowrideit]

Thank you very much blt, I think Im gonna do like 44-45

[Nissanshift350]

Originally Posted by blt456

Exactly my friend.
If you use torque gears, I take you'll be drifting.
Then you should still use around 40 turns.
37 is the dead limit.

Okay well redsxmodder said on xmf that 45 turns is the lowest a stock fet evo chassis so I have been running 50 turns in a can with iso mags from a crest spin brush

[2wdpancar]

Originally Posted by Nissanshift350

Okay well redsxmodder said on xmf that 45 turns is the lowest a stock fet evo chassis so I have been running 50 turns in a can with iso mags from a crest spin brush

Ok, well I thought 37T was the lowest, maybe I should speak with him...

[Nissanshift350]

Originally Posted by blt456

Ok, well I thought 37T was the lowest, maybe I should speak with him...

Well do please let me know what my limits are lol. I want to wind the lowest wind number possible with out blowing my fets. And I run my hand wound motors in evo chassis only