#1
|
|||
|
|||
Broken Scion might be rising from the dead!
i was going to do a 6 cell in my PN scion, so instead of putting it in there first i decided to try it on my returned scion to make sure i know how to do it right. well i got it on the returned but i decided to take out the whole EP for no reason then i soldered back on all the wires and stuff and i turned it on and it centered the steering! it wouldnt do that when i first got it, but i try to steer and make it go with the controller and nothing happens. so whats the problem? why wont it steer or go? well heres a pic of the chassis it didnt look like there was anything fried though so idk waht to do now.
|
#6
|
||||
|
||||
is the motor good?is it whirring?is there any signs of damage to the board?
__________________
IF YOU NEED A MODEL BODY MOUNTED I CAN DO IT! Quote:
Quote:
|
#9
|
||||
|
||||
maybe its your board . i found 1 on ebay its the cheapest i seen yet
buy.it.now is $12.99 + $3.00 shipping http://cgi.ebay.com/EVOLUTION-ELECTR...QQcmdZViewItem or u can try bidding on this 1. the current bid is 0.99c +5.99 shipping http://cgi.ebay.com/Xmods-Xmod-Evo-E...QQcmdZViewItem |
#13
|
||||
|
||||
It's hard to see in the pics but i know what when i did my 6 cell the tolerances around the black wire you desoldered were very tight and it would be very easy for you to cross a connection (which would probably ruin your ep). Try to take a close up pic of the connection where the new black wire is soldered to the board.
|
#14
|
|||
|
|||
i didnt solder anything, all i did was cut the black wire in half, i took the red wire from the 6 cell and twisted it together with the black wire coming from the battery tray. then i twisted the black wire from the 6 cell to the black wire thats already soldered to the EP
|
#15
|
||||
|
||||
he doesnt have marco on his camera so it might not get a better look in a nother pic
__________________
LOOKING FOR 350Z MINT FRONT BUMPER!!!! Quote:
|
#18
|
||||
|
||||
lay the board on something that is completely white and snap a shot about 8 inches away from the board.
then use PS or paint to zoom. to zoom with paint, use the magnifier tool and zoom in on the board. then hit the insert/print screen key. now select your outline tool,right click and hit paste. now you should have a magnified shot of the board. trim the edges,save it and post it on your pic server. your problem is kind of a tricky one since it wasnt working when you got it. if it was from the other guy jumping off ramps then it most likely jarred a wire or transistor loose.
__________________
Time you enjoy wasting is not wasted time.... |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|