How to lift body for muscle Cars

[Bananabrain]

Difficulty 2/10

Takes about 2-5mins

Ok, well i figured out a quick and easy way to lift a muscle car, to give it a more agressive look on the rear.

Step #1:
Items needed:
Your xmods screw Driver
A small Flat Head Screw Driver
Your Xmod Body
Xmod Rear Clip
Xmod Chassi
2-56 Round Head Machine Screws & 2-56 Machine Steel Nuts

http://i362.photobucket.com/albums/oo63/bananabrain_07/001-8.jpg

Step #2
Take your Body & Unscrew the Rear Clip
http://i362.photobucket.com/albums/oo63/bananabrain_07/002-7.jpg

Next take out one of these three 2-56 Round Machine Head Screws
http://i362.photobucket.com/albums/oo63/bananabrain_07/003-5.jpg
(You can use any length, but i used the middle length one)

Step #3
Take Whatever Screw Length You picked & put the Machine Steel Nut on it and screw it almost all the way down& if your worried about the nut coming unscrewed put a dap of model glue or hot glue on it, so it makes a temporary hold until you ready to remove it.
http://i362.photobucket.com/albums/oo63/bananabrain_07/004-5.jpg

Then Start Screwing it down, until you get the Right Height Your Looking For. (This is when you can test it to see if you like the Height or not)
http://i362.photobucket.com/albums/oo63/bananabrain_07/005-3.jpg

Here is How Mine Turned Out.
http://i362.photobucket.com/albums/oo63/bananabrain_07/006-6.jpg
Also One Reason Mine is So high is because i 6 celled it and i need to mount it on the roof of the car, so i can sit it lower. (Im out of Micro Dean Plugs) :D

All Comments & Tips Apperciated

[iiNFuSiON]

Very nice tut tahnks.