Evo Truck Boards

[Ducroix]

I got an f150 from a friend but he fried the board, is it complicated to switch it out with a new one

[supraboi97]

It will be hard if your not good at soldering other than that it shouldnt be just cut the wires and solder them where they need to go

[Ducroix]

Ok good, I'm not horrible at soldering he took it through a puddle like an idiot and fried it so he gave it to me because he bought 3 gen 1's off ebay

[taiwanesekid05]

If you can solder a regular Evo board, then you can do a Truck board too. Remeber the 3 seconds on and 3 seconds off rule so you don't burn your board.

[2wdpancar]

To add to ch05's post, also keep in mind if you hve any solder loose or bridging, you're kinda screwed.
Soldering the wires isn't that hard...I recommend soldering the motor wires to the board while you're at it.

Don
t forget to take out your crystal and antenna.

[superinfinity]

hey, when your soldering the motorwires to the board, they probably wont stick well if you use rosin core solder. If you do use rosin core solder or not, take a razor and gently scratch up the motor pads. this will give the solder something to grab onto. Hope this helped

[xmodscarbon's_lost]

Its not to hard i suck at soldering and i can do it in like 5-10 min. so give it a shot and don't let the steering servo wires touch or it may fry or not turn right.And if you fry it just buy one from rs and you'll be good.
Hope it works,
chaoe.

[Ducroix]

Thank you all for the help

[xmodscarbon's_lost]

Originally Posted by Ducroix

Thank you all for the help

Your welcome!

[Ducroix]

Just gotta order one and rebuild