i messed up

[NeoFRANK]

ok i need help .. when disasembling my mod .. the wires conencting to the batteries have broken off .. can i get sum help on where they go .. pic's would be a HUGE help .. all i need is a pic of a complete one and ill look off that or sumthing .. plz help thanx

[Dropped_Civic]

JUST SOLDER IT BACK ON

[xmodmaverick]

you can do it the easy or the hard way. the easy way might melt your batt holder tho:

EASY WAY:
1. slide batt holders all the way to the back to expose the 2 square holes where the battery wires go into.
2. solder

HARD WAY:
1. remove board cover by removing:
A. the motor wires
B. the antena
C. the crystal
D. the screws on the top of spacer
E. any leftover screws on the light grey part of the car
2. remove one screw that holds the mainboard in place located near the
FET's and a red wire
3. flip over mainboard to the LEFT side of the car so you dont break off the
survo wires.
4. there is a red and black wire on each side. these are the batt wires.
5. solder

sorry i don't hav pics. i will update this post later and post some pics.

[WRX Ryder]

this is not very helpful but just buy a 5 or 6 cell and look at its tut. that way it can show how to reconnect them back plus add an extra battery or two. i dont know if you already have a 5 or 6cell though.
One reason why its best to buy an evolution!!

[jeremyk2111]

http://www.atomicmods.com/custom.aspx?id=43 http://www.atomicmods.com/custom.aspx?id=27 this may help u

[bengali548]

just remember positive to negative and vice versa