|
|
|
#1
01-12-2006, 05:10 PM
|
|||
|
|||
i need help
If i was to install a nuke 130M would i have to increase my Fet s and will a heat sink work to keep it cool
__________________
Yellow Nissan Skyline GT-R V-Spec. 
|
|
#2
01-12-2006, 05:19 PM
|
||||
|
||||
|
Yes you need stacked fets or V2, as for the heat sink I'm not so sure.
:edit: Just as an afterthought, there are other motors out there, and there is a number of different heatsinks that you could look at. Figure out what best fits your needs and wants. Also, you will have to put a pinion on the nuke motor (the gear), just incase you didnt know. Last edited by Jonisawsom; 01-12-2006 at 05:26 PM..
|
|
#3
01-12-2006, 06:42 PM
|
||||
|
||||
|
you DONT need a fet upgrade for the 130 SM but is recomended
__________________
CRUNK RIDAZ, WE NEVER BACK DOWN!
|
|
#4
01-12-2006, 07:00 PM
|
||||
|
||||
|
Nuke 130 Motor
After the first black dot please read. It says requires: for gen 1 xmod a pinion .... stacked FETs, or V2 .... Don't take my word for it, please go read for yourselves.
|
|
#5
01-12-2006, 07:02 PM
|
||||
|
||||
|
wow never new that, normally 130 sized motors dont need 1
__________________
CRUNK RIDAZ, WE NEVER BACK DOWN!
|
|
#6
01-15-2006, 07:40 PM
|
|||
|
|||
|
What about a fat boy hc
__________________
Yellow Nissan Skyline GT-R V-Spec.
|
|
#7
01-17-2006, 12:44 AM
|
|||
|
|||
|
that definatly needs fets or a v2 the fets i would go a 3x2 stack
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
