#1
|
||||
|
||||
Help for fet satcking for gen 1!!!!!!!
i need help with stacking fets. what kind should i use? any tips on installation? and any places that have a tutorial? Or should i just get the V2.2 board? there u go.
Last edited by bobt; 02-11-2007 at 10:25 PM.. |
#4
|
|||
|
|||
i THINK you can use 4562's on gen 1s. im not sure of it though. but the V2.2 would be easier to install.
|
#5
|
||||
|
||||
Quote:
Anyway, I would suggest an aftermarket turbo kit (Woah Nelly or the V2.2) If you want to go with the FET stacking, you can just purchase the correct FETs, to make the process easier, just glue the FET on top of each other so that they don't move then solder them together. |
#6
|
||||
|
||||
i run tripple stacked 4562 FET's on my subaru (gen1 ep) and i used the tut from atomicmods.com to do it. the only thing they didnt mention, but would have been really helpful, was to do like REDisFASTER said, and to use a tiny bit of glue between them, it makes soldering WAY easier.
__________________
Mine's faster! My for sale thread: NEW!! Check out recent discounts and special offers! THE EDJ'S FOR SALE THREAD |
#8
|
||||
|
||||
Ok sorry to hijack the thread but it seems relevant.
I plan on getting the atomin ball bearing case and putting the 38 turn armature into it, now this will require stacking the FETS, would this just be a 2x2 stack or would I be better off with a 2X3 stack? this is for gen1. also should I remove the stock FETS or can I just stack the new FETs right on top of them?
__________________
H2/f-150 - offroad vehicle, s1 hybrid, lift kit, custom lights F-150 - Doughnut machine Firebird - back from the dead, drag car eventualy EVO VIII/subbie - currently at around 50% Finaly on a chassis Corvette - currently at around 15% Red Supra - in the mail |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|