How to water-proof electronics ??

[dccracing]

Originally Posted by Riellyc

Don't know if this has been said but if you put the wax that you recieve if you have braces on the board it works great and isn't to hard to take off. It also does not melt easily...

that or if you ski or snowboard, you can buy ski wax and stick the wax on an iron over the board. let the wax drip down onto the board

[supraboi97]

Originally Posted by dccracing

one thing i have never tried that might work is hot glue. just as long as it isn't too hot. i think it would kinda incase the electrics in a bubble of rubber... lol. bubble of rubber

Hot glue will work i have made a waterproof camaro and i just put hot glue over the entire board and servo motor and the end to the car motor and relocated the battery pack so it would sit above the car by a good 4 inches and as long as the battery pack didnt go under the car ran fine.

[dccracing]

ok. cause that just poped into my brain and i thought it would be a good idea. probably imposible to remove if you fry something or you want t upgrade

[snowboi1289]

liquid electrical tape will work perfectly. Its been done plenty of times with other scales.