#1
|
||||
|
||||
motor help
i am going to put the motor from my sig in my xmod after i rewind it to a more reasonable amount. but my redneck rigged voltage tester says six at the solder points on the motor but im not sure. so what is the woltage at the motor points. and also what turns will a stock fet set take.
__________________
YOU JUST LOST THE GAME!!!! im not as think as you drunk i am 53 chevy crawler 100% fast and the furious tokyo drift mustang 100% rsx rally car 80% nine in the quarter100% HMU on live folks MrHotRod1971 |
#2
|
||||
|
||||
6 ...................6 what volts ?
how and why are you measuring volts on the motor ? what you need to find is the ampage and 45 turns is a safe limit for stock fets
__________________
TEAM XI I AINT NAMED REAPER COZ I CUDDLE BUNNYS ! XMS and XMF february COTM winner |
#3
|
||||
|
||||
6 is what it takes to light my voltage tester up and i tested at the motor to try to add all of the resitance to the motor
__________________
YOU JUST LOST THE GAME!!!! im not as think as you drunk i am 53 chevy crawler 100% fast and the furious tokyo drift mustang 100% rsx rally car 80% nine in the quarter100% HMU on live folks MrHotRod1971 |
#4
|
||||
|
||||
i will ask again 6 what ? volts -amps -ohms -monkeys ?
if its volts then all you are doing is measuring what your batteries are pushing through the board again this will tell you noting what are you trying to find out maybe i /we can point you in the right direction
__________________
TEAM XI I AINT NAMED REAPER COZ I CUDDLE BUNNYS ! XMS and XMF february COTM winner |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|