motor magnets

[drofants]

well i found an old sb motor i had laying around, and i took out the mags and forgot to label them right and left (i know stupid me,). well i also found some other size 130 motors and was wondering how to tell the difference in mag power (reg, iso, and neo) and also how to tell the left and right mags or the right orientation of them? because i read somewhere that you have to install them the same way you took them out (or i may just be wrong).

I know i don't have neo at least....

[Donziikid]

Seating your magnets:
http://www.atomicmods.com/Categories/QandA-Motors.aspx

Originally Posted by AtomicMods

Which way do the Neo Magnets go in?
Place the motor on the table with the magnet stop ridges on the bottom like shown and slide them in like this with the black mark on the right. If your motor runs backwards, you will know you got them backwards. You could reverse the wires to make it run the correct direction, but this affect your motors timing.

The same applies for all of your magnets; no matter the type of magnet it is.

[drofants]

omg, i made a motor that worked.... don't know how but it does...... i used it on my testing ep and it worked! prolly worse then a stage 2 but better then a stage 1 plus its ugly because i can't solder to save my life....

nvm i'm sure now it has more torque!.....i'd still never use it on my supra thou

[stang_racer]

ummmm pics???? or vid????

[stangdude94]

well i have a question how the hek do you get the motor magnets out to replace them i want to put stronger magnet in my s1 and they wont come out pics or videos would be nice thanks in advanced

[drofants]

this should help you

http://www.xmodsource.com/forum/showthread.php?t=6077

if not scroll up and check what donz posted