![]() |
#1
|
||||
|
||||
![]() My TC evo fets just fried which is surprising since it was running last night without any problem. There are a couple of things that I wasn't sure about on the motor when I checked it. The little brown tab between the two wires was broken and the little metal "wires" were touching. The only thing that was bugging me was the fact that I didn't change anything on it from when I ran it last night and it was running without any issues. So now I need to know if the issue could be caused by the "noise" rf being broken or if it was just a freak thing. I'm also now looking for a stock evo board and stock evo motor as a result lol.
__________________
Road Course '08 GT-R Rally Scion TC (off road mods in progress) Sharing EVO chassis for now. |
#2
|
||||
|
||||
![]() by little thing
i take it you have cracked a capacitor on the motor , if this is the case and the wires were touching then thats your problem you have just put a dead short across your board best way i can think of blowing fets
__________________
TEAM XI I AINT NAMED REAPER COZ I CUDDLE BUNNYS ! XMS and XMF february COTM winner ![]() |
#3
|
||||
|
||||
![]() That's what I thought, if I could seperate the wires again, and replace the FETs do you think it would run again or will I have to get a new motor as well?
__________________
Road Course '08 GT-R Rally Scion TC (off road mods in progress) Sharing EVO chassis for now. |
#4
|
||||
|
||||
![]() it should be fine
seperate the wires and try the motor on a seperate battery just to be sure but i doubt it will have damaged the motor
__________________
TEAM XI I AINT NAMED REAPER COZ I CUDDLE BUNNYS ! XMS and XMF february COTM winner ![]() |
#5
|
||||
|
||||
![]() the motor runs when the wires are seprated so once I get new FETs and the V2 chip like you suggested it should run alright and also like you said I can run a faster motor
![]()
__________________
Road Course '08 GT-R Rally Scion TC (off road mods in progress) Sharing EVO chassis for now. |
![]() |
Currently Active Users Viewing This Thread: 5 (0 members and 5 guests) | |
Thread Tools | |
Display Modes | |
|
|