#1
|
||||
|
||||
Gen 1 question
where can i get the full electronics with tight turns already installed. i recently messed up both my gen 1's i wanna work on a rebuild but im not good soldering on something so small. xmodsinternational used to have them but not anymore.
thanks for the help guys |
#2
|
||||
|
||||
I believe Atomicmods sells electronics with different setups such as the tight turns
__________________
"Jones' BBQ and Foot Massage!" Current cars: (in storage, erm 'in the garage') ____________________________________________ Nissan Skyline (Black) Nissan Skyline (Yellow) Honda Civic (Blue) Acura NSX Acura RSX (Black) Evo Lancer VIII Evo 05' Mustang Mustang Cobra SVT Toyota Supra (Silver) Nissan 350Z Subaru Impreza STI Nissan GT-R Dodge Challenger |
#4
|
||||
|
||||
Expect to pay out the ___ if you order from AtomicMods.
Best bet to save the bank is to source a board from somewhere else, and have a (repuatable) member instal Tight Turns.
__________________
After a thousand years of oppression,
Let the berserks rise again, Let the world hear these words once more: "Save us, oh lord, from the wrath of the Norsemen" |
#5
|
||||
|
||||
or you could try to source out some of those resistors that you just splice into the servo wires instead of sodering on the board... but youd still need a new board
__________________
Olive 2000 v70R
|
#6
|
||||
|
||||
I can set you one up affordably as well. I happen to have some Xmod Gen 1 boards in stock. PM me if interested. I'll stack FEts and install tight turns. As you might know I"m an approved service provider! I might even have one already prepared.
Last edited by Action B; 10-05-2009 at 12:20 AM.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|