spacers?

amorton94 · #1 07-07-2008, 11:07 PM

i'm in the process of making another h2 crawler, but i took of the motor cradle, one of the spacer/bearing fell off one of the gears. does anyone no where i can get another one of those? i need one, the gears won't even move when i put the cradle back on, so please help me with this problem.

GearHeadV8 · #2 07-07-2008, 11:15 PM

have you tried looking lol.if have a 4wd anywhere that is not in use use the bearing from it

amorton94 · #3 07-07-2008, 11:21 PM

Quote:

Originally Posted by crazyxmoder

have you tried looking lol.if have a 4wd anywhere that is not in use use the bearing from it

yah i hav looked, i don't have another 4wd , i just want this one to be functional again

GearHeadV8 · #4 07-07-2008, 11:24 PM

do u have any other cars or trucks

amorton94 · #5 07-07-2008, 11:29 PM

yah, but i don't want to take the spacers from them

GearHeadV8 · #6 07-08-2008, 12:37 AM

lets see lol umm if u r good with a drill take out the spacer the one you have and find a drill bit that is like the same size.then find a like soda cap and trace the outline of the spacer use like a knive or dremel to cut around then use the drill to make the center whole lol.tell me if u still dont get it

amorton94 · #7 07-08-2008, 01:14 AM

Quote:

Originally Posted by crazyxmoder

lets see lol umm if u r good with a drill take out the spacer the one you have and find a drill bit that is like the same size.then find a like soda cap and trace the outline of the spacer use like a knive or dremel to cut around then use the drill to make the center whole lol.tell me if u still dont get it

it would take alot of layers to make one, but i think i will try to make one out of the xmod case

madcat303 · #8 07-08-2008, 01:25 AM

do you have a motor case, that is junk? take off the rear case, with the two wires, take out the armeture, the place the case with the lil' hole facing up, the take a screw drver and hammer,pliers, and tap on it until it comes out, it looks like the bearings, it is only abit smaller, but it will work, try using hot glue to hold it in place, hope this helps, ill post a vid, if you want?

GearHeadV8 · #9 07-08-2008, 01:25 AM

lol go for it tell me how it turns out

madcat303 · #10 07-08-2008, 01:38 AM

do you mean my idea, or bottlecap, or xmod case? curios, sorry

amorton94 · #11 07-08-2008, 01:38 AM

Quote:

Originally Posted by madcat303

do you have a motor case, that is junk? take off the rear case, with the two wires, take out the armeture, the place the case with the lil' hole facing up, the take a screw drver and hammer,pliers, and tap on it until it comes out, it looks like the bearings, it is only abit smaller, but it will work, try using hot glue to hold it in place, hope this helps, ill post a vid, if you want?

a vid would help