Xmods Ferrari Enzo Track car Project

[xmodsunlimited]

Originally Posted by mr.hotrod

glue screws to the inside of your body and drill holes in the battery straps.

okay is there any tuts on that?

or could you post pics to tell me what you mean.

Thanks

[XMDrifter]

make a slot in the rear battery pack plastic, like a mini-z mr-02, then take the mini-z sideclips and trim them little by little till they slot in the slot, then make sure both slots on the chassis are symmetrical and glue the side clips to the inside of the mini-z body on the clip rails at the body height you want.
adjust the battery pack position until the front wheels line up just right, then secure the battery packs. extend the rear until it lines up, then you're done with the body conversion.

edit:
the mr-015 is a good example:

[pinsk17]

Josh, this may be the easiest way.

[xmodsunlimited]

Hey everyone, as an update and close out to this thread, I thank everyone for there ideas. However. I am in need of money.............so i can buy other things so I had to end this project premature . If interested it is on ebay right now.


Thanks again.

I do plan on doing custom model body mounts in the future..........................A Subaru 2.5rs perhaps.

-XMU

[96SVT281]

everybody is feeling the hurt for money right now good luck to you