Gtr Wheels

[deckerz]

ok so iv fixed the glitch on my chassis but ignore that, iv put the lowering kit on my chassis but the body i think is still not low enough because there is loads of space still between the wheel and the top of the wheel arch, anyway i can fix this or anywhere i can get 1/24 model car spares?

[Skv012a]

Just scratch build a new front clip to lower the front and i'm not not too sure about the rear.

[Blackdragon]

Remove your rear clip, take a file and start filing down the rear clip mount 'till you get it where you want it but to that you will be mounting and un-mounting your rear clip. Only a couple of times though. Just be sure not to take it to low while filing the rear mount.

[XMDrifter]

if you happen to file too far, then get some styrene and glue it to the mount and start filing again