Barricade Light Kit

[donjuan28]

I have 4 Evo kits, 3 brand new and one purchased when they first came out. I have two Barricades and purchased the light kit for both. Why can I not have the command logic light kit and Barricade's light kit on at the same time?

When I flip the switch, the tailights stay on all the time, and the headlights turn on when I move forward, but the top police lights I can barely see them light up. They work fine by themsevles, but when both are plugged in I have issues. Any suggestions would be greatly appreciated!

[xmodscarbon's_lost]

The problem could be it's to much power for it to supply to both at the same time.You could wire the head and tail light to the Berricade light kit board like i did but you decide it is yours.Hope this helped!

[donjuan28]

So I guess you had the same problem also? That does sound like a good idea. I'll have to play around with it.

[xmodscarbon's_lost]

Yes it did just what you said.

[imnotmikal]

This is just what happens when you try that.
It always happens, and theres pretty much no where to run both.

[jameslew]

or wire it to its own AAA battery.

[ling427ttvette]

So, if that's too much power for it to handle then why did they build two plug ins for lights into the electronics? That makes no sense.

[xmodscarbon's_lost]

Originally Posted by ling427ttvette

So, if that's too much power for it to handle then why did they build two plug ins for lights into the electronics? That makes no sense.

It only allows so much power to go to them so...........Thats why.