Go Back   XmodSource.com > Xmods > XMOD Electronics
Register FAQ Members List Calendar Gallery iTrader Today's Posts

Reply
 
Thread Tools Display Modes
  #1  
Old 01-29-2014, 04:28 PM
n7plus1 n7plus1 is offline
New Member
 
Join Date: May 2008
Posts: 4
Trader Rating: (0)
Default PN Racing 32-T Motor only lasts about 5 seconds

before you have to let it sit for another 10 seconds to run it again.

Its a street board, 2x3 FET stack.

Full throttle lasts like 4/5 seconds and you have to let it sit to get another 4/5 seconds out of it. I did my own FET stacking. Is this a problem with the FET's? Did i ruin some while stacking...IE - leaving too much heat on them too long while installing them?
Reply With Quote
  #2  
Old 05-20-2014, 02:36 PM
n7plus1 n7plus1 is offline
New Member
 
Join Date: May 2008
Posts: 4
Trader Rating: (0)
Default

bump? i ordered another set, this time 2x2's and continue to have the same issue. Servo, this time, is running all of the time.
Reply With Quote
  #3  
Old 01-04-2015, 02:32 AM
XMDrifter's Avatar
XMDrifter XMDrifter is offline
drifter and engineer
 
Join Date: Jul 2006
Location: St Louis
Posts: 2,179
Trader Rating: (5)
Send a message via AIM to XMDrifter
Default

It's likely the radio reception from your remote. this cutout happens when the remote cannot output a clear signal to the board. try a fresh remote battery, and fresh car batteries. if it still doesn't work then it's possible you guessed it right with overheated chips (they can really only take around 10 seconds or less of solder heat.)
__________________
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:37 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.