EVO truck board help

[KCowboy620]

Hi I hope this is in the right place I got a hummer evo truck off ebay last week and when i got it there was a black and white wire that was only attached on one end and if someone could post a picture, send me a picture, or explain where it goes that would be greatly appreciated because now it won't turn and i think thats what causing it to not turn. thanks in advance
KCowboy620

[dontspamme]

Do you have a picture ? Or a better description ? I'm assuming it's under the board cover, and that sounds like your servo wires have fallen off. Heres a picture of the board. It's a Evo touring, but same board. As you can see, the white wire faces the rear of the chassis, and the black wire is just in front of it.



Picture from Atomicmods.com

[KCowboy620]

Originally Posted by dontspamme

Do you have a picture ? Or a better description ? I'm assuming it's under the board cover, and that sounds like your servo wires have fallen off. Heres a picture of the board. It's a Evo touring, but same board. As you can see, the white wire faces the rear of the chassis, and the black wire is just in front of it.



Picture from Atomicmods.com

ok thanks it was attached to the board only so it must have came off the servo like you said thanks

[winner]

just make sure your really good at soldering.. if you arnt find someone that is