#2
|
|||
|
|||
not really your better off just buying the pinion pullers so you dont mess up the pinion
__________________
http://deerman270.proboards41.com/index.cgi |
#3
|
|||
|
|||
pinion pulling
yeah put vise grips on the pinion and holde so the pinion is facing up and stick a nail or needle etc. into the tip of the pinion and hit it with a hammer until it comes out
__________________
http://www.geocities.com/cdy876/neon.jpg |
#4
|
||||
|
||||
Re: pinion pulling
Quote:
__________________
Pete M. Armadillo Motorworks and Graphics Fresno, CA Built!!!!: Team Losi XXX-S with an HPI Saleen Mustang body. Yeah, time for some real R/C. Team site: http://home.earthlink.net/~teamamg/ |
#5
|
|||
|
|||
Re: pinion pulling
Quote:
how do you use the soldering gun to dis pm me please need to know
__________________
Znd racing team got rice? Any one here......hello?! |
#6
|
||||
|
||||
Allow the gun to heat up fully, once heated apply the tip of the soldiering gun to the BACK of the gear, away from the motor. it only takes a few seconds, no more than 15. With a pair of needle nose pliars push the gear off the shaft from the motor side, DO NOT GRAB THE GEAR, the heat will make it softer and easier to bend. This works best with the motor out of the car but secured with vice grips (gently).
__________________
Pete M. Armadillo Motorworks and Graphics Fresno, CA Built!!!!: Team Losi XXX-S with an HPI Saleen Mustang body. Yeah, time for some real R/C. Team site: http://home.earthlink.net/~teamamg/ |
#7
|
||||
|
||||
Re: ummmm
Quote:
|
#8
|
|||
|
|||
solder
that soldering thing didn't work for 5H!T
__________________
http://www.geocities.com/cdy876/neon.jpg |
#9
|
||||
|
||||
Works for me, I have a pretty hot gun and it works everytime.
__________________
Pete M. Armadillo Motorworks and Graphics Fresno, CA Built!!!!: Team Losi XXX-S with an HPI Saleen Mustang body. Yeah, time for some real R/C. Team site: http://home.earthlink.net/~teamamg/ |
#11
|
||||
|
||||
I just take a sledge hammer and smack it ....lol...jk..just take the motor and hold it on something solid and take a small hammer and something to pertect the pinoin (piece of wood or leather) and tap it on but make sure you got the back of the motor shaft on something solid not the motor can or you might drive the hole shaft back insted of the pinion going on...
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|