Making History??

[2wdpancar]

Originally Posted by bestdragon2001

Do you think you could make a wiring diagram or tut pretty soon, I just want to know how you did it.

Yeah I will.

I just want to get it running then I'll make a tut.

You're putting it in an evo, correct??

[bestdragon2001]

Yeah Ill put it in my evo viper. Why did you cut the roof off like that?

[2wdpancar]

Originally Posted by bestdragon2001

Yeah Ill put it in my evo viper. Why did you cut the roof off like that?

To fit the board.

I could've sworn I put this somewhere else, but I wanted to mount it really easily with lots of support, plus it looks cool.
To me atleast..

[bestdragon2001]

My body is a covertable so I hope I dont have that issue.

[2wdpancar]

Originally Posted by bestdragon2001

My body is a covertable so I hope I dont have that issue.

Well just mount it lower than how I did, and you'll be ok...

What motor do you have in mind?

[bestdragon2001]

Well Ive been winding a couple on my own but I have no idea how to pattern wind, but mine work good. I was thinking a 38 turn in an atomic case.
Do the atomic cases come with neos?

[2wdpancar]

Originally Posted by bestdragon2001

Well Ive been winding a couple on my own but I have no idea how to pattern wind, but mine work good. I was thinking a 38 turn.

You can run 37t, but make sure it's around 40.

I just want to point out...people think that a plasmatomic will run on this board stock, wrong.

These are not MOSFETS, you need a 2x2 of mosfets to run a plasmatomic.

These fets aren't any better than stock mini-z fets.
So, just keep that in mid people, I hope those of you who plan to do a conversion take that into consideration.

[xmodificationer]

I might take my micro-t and do this. I can do the swap and everything but how will I get a xmod servo to work with a micro-t? because they are 5 pin

[bestdragon2001]

Thats the whole point he figured out how to do it, he said hes gonna make a tut too.

[2wdpancar]

Originally Posted by xmodificationer

I might take my micro-t and do this. I can do the swap and everything but how will I get a xmod servo to work with a micro-t? because they are 5 pin

2 wires are for the motor, 3 are for the POT.
You don't need to remove the POT wires.

I realized my turning is aight...I still need to get and slap in some 3.3k resistors on the pot.
Then it should turn better.
Also the micro-t board makes a little noise in the actual losi chassis, if you are quiet, you'll hear it.
In my supra it's LOUD!!

Originally Posted by bestdragon2001

Thats the whole point he figured out how to do it, he said hes gonna make a tut too.

Yup, thanks for reading.