#1
|
|||
|
|||
Pinion Gears?
I just got my Speed BB motor in and it did not come with the pinion attached. Where can I get one for it? Also how to you take the ones off the original motors and reuse those?
Thanks Guys
__________________
My Garage TL01,T-Maxx 2.5, Nitro 4tech 2.5, Ofna MBX Pro .26, Xray M18, Stampede, HPI Dash, (2) Xmods, Dragon Fly Heli |
#2
|
||||
|
||||
You need a pinion puller to get one off your old motor, or you can buy a pinion set from Atomic Mods and just hammer it on. Just make sure the motor is resting on metal, or you could destroy it when putting it on.
__________________
Just say no to giant sigs. |
#4
|
||||
|
||||
dude,just use a torch and something to hold the motor and pull the pinion off with. all you have to do is heat up the pinion with the "hottest" part of the flame blue,purple,or green depends on the gas your using and pull it off then put the pinion on with a brass hammer. PS:iceman i have a trx 2.5 traxxas tmaxx to lots of **** done to it,59.8 mph i clocked it at.
__________________
Snobro Ford F-150- Hi-Torque motor-Four wheel drive-custom body. Gen 1 Camaro-drift set.-gen 2/stage 2 motor Go Patriots!!!!!!! |
#5
|
||||
|
||||
just get a pinion puller
i recently got one for $13.56 at a hobby store they work like a charm i highly suggest one
__________________
I've got 2 working XMODS and enough parts to make another 4, a Traxxas TMAXX w/3.3 race motor, and 2Nissan 240SX's. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DAM GEARS!!!!! | RadioShackGuy | XMOD Modification | 10 | 11-13-2004 08:23 PM |