stalling

[kbekbe]

what if i take out the spacer?

[winner]

Originally Posted by kbekbe

what if i take out the spacer?

the spacer is what hold the motor at the degreet it needs to be at, you could try it, but it would probbly not work?

[kbekbe]

it was kinda warped

[winner]

ok, yours deffintly looks a bit melted, i'll take pics of what a stock one should look like in just a sec, but that is more then likely what is setting the motor out of place

[kbekbe]

yea when i took it out and placed the motor in it fit perfectly

[winner]

Originally Posted by kbekbe

yea when i took it out and placed the motor in it fit perfectly

be careful when you do that because it will make the motor sit tighter then its suppose to and over time may mass up your gears from not meshing correctly

but heres what it should look like


i have alot of extras, i'll give you one

[kbekbe]

yea its definitely warped even cracked
just look at my previous picture

[winner]

Originally Posted by kbekbe

yea its definitely warped even cracked
just look at my previous picture

lol thats why i said it looks melted and im getting you a new one, but for now you mite can sand down that part to its even with the rest and it should work fine till i give you the new one

[bosco72]

use tape to the thickness of the spacer for now

[kbekbe]

kk thnx

[kbekbe]

so now until i get a new spacer i'll use bosco72's idea with tape

[reaper]

Originally Posted by kbekbe

now when i hold the tire and press the trigger ]

glad you got the problem sorted ,just to point out dont EVER do this /\ it will over strain your car and possible blow your fets

[winner]

Originally Posted by reaper

glad you got the problem sorted ,just to point out dont EVER do this /\ it will over strain your car and possible blow your fets

+1 its a bad idea, just wait till tomorrow and i get you a fresh spacer

[kbekbe]

and one more thing
how do u take off the front side of the xmod?

[lol]

There are 2 screws in front of the xmods gearbox. 1 under the front upper arm, and 1 under the chassis. Then unscrew the screws holding the tierod to the knuckles.

If all else fails, unscrew everything.

[kbekbe]

could u say that in another way because i dont know wat a tierod or a knuckle is

[winner]

knuckle= what holds the bushings+cvd's

tierod= the rod that helps steer the front wheels

[kbekbe]

could u show me tomorrow winner?

[lol]

Knuckles are circled, The screw arrow pointing at is the one you remove to open gearbox. There should be another one parallel to it under the front clip. The screw behind the ones that hold the front clip.



After you get those 2 removed? remove the screws from the steering link.

[winner]

Originally Posted by kbekbe

could u show me tomorrow winner?

sure but i think lol beat me to it lol...