#1
|
|||||||||
|
|||||||||
This is project rice rocket
i stated with this
and then this
and soon to come lipo powah! battery i may use Picture 90 by Antxmod, on Flickr ricerocket step 3 -shortened wires - lipo plug installed -needs more soldering tho.... Picture 91 by Antxmod, on Flickr one of the minizs im gonna race when im done
__________________
Xmodding is coming back? I need someone to stack fets and redo wiring on my zmod. Pm me Last edited by DRFTKO; 08-25-2011 at 01:04 PM.. Reason: double post |
#2
|
||||
|
||||
Got most of the soldering done but when i drive it shuts down after 1 minuete it goes to fast to really drive it in the house so next time i go to the track ill test it better.
also its a mini z board so im pretty sure there is no low lipo cutoff driving
__________________
Xmodding is coming back? I need someone to stack fets and redo wiring on my zmod. Pm me Last edited by AntxmodMiniz12322; 08-25-2011 at 03:21 PM.. |
#3
|
||||
|
||||
I need help my mini z board isnt working so I'm putting in a micro t board and I need a micro t servo soldered to the pin connector I don't have the male plug can I send it to anyone that could solder it?
Thanks
__________________
Xmodding is coming back? I need someone to stack fets and redo wiring on my zmod. Pm me |
#4
|
|||
|
|||
For my experience miniz boards... work well with li-fe baterys, the 6.6v range!
Li-po ones have 7.4v, and that's the max the board handles. so you are playing red line, work with li-fe baterys instead. Great upgrade from 4.8v cells! With li-po you will kill all your mini-z board, AM or 2.4ghz sooner or later! To work SAFE with 7.4v only the "toy" x-mods "crap" PCB, or the perfect Micro Losi Boards from Micro Rally or Micro SCT! These are build from the ground to acept at stock 7.4v the losi ones peace! |
#5
|
||||
|
||||
i need someone to solder a servo to a microt board post if you can do it ill pay for shipping
__________________
Xmodding is coming back? I need someone to stack fets and redo wiring on my zmod. Pm me |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|