![]() |
#22
|
|||
|
|||
![]() Update.
Been up drinking, and tinkering. Lastnight that is, then I found it today in the morning, after forgetting what I did lastnight. I realize that I cut up the interior and did some mock up items for the driveline issue, but now I need to fix the rear suspension cause' I think it may be out of wack right now cause of this. Anyhow, this is the final completion of the rear end, with stiffer items that are not styrene/sheet plastic, it's a 7UP can! Go figure what you have when your done drinking. ![]() ![]() The Engine will be over top of the Bevel Gear, it should rotate like a normal xmod... I'm hoping atleast. ![]() Connection between the rear differential and rear bevel gear.(Hole will be fixed when body work starts haha.) ![]() She's got plently of clearance, she's just up on a 1/2inch lip on the front so the rear looks like it's close to dragging. ![]() And that is the bottom, the middle part came out perfect, and that is what was needed greatly to make the drive-shaft a semi-floating driveshaft. She's getting closer, I'm hoping the steering linkage will clear where the "engine"(motor) will be sitting... I really hope... Anyhow, C&C please. Blade. |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|