![]() |
#1
|
||||
|
||||
![]() I noticed that people wanted to raise their titan/h2 bodies, which is different than raising the f150
What you'll need: A screw driver A nut driver 3 LONG screws(not shown) 9 2-56 hex nuts from radioshack(they come in a pack of 40 and can be used as wheel nuts as well) and yes the little boy in the pic is me when i was young ![]() first you flip the front clip(for the people who want details. stock height of body from ground to fender is 3.8cm with off road kit tires with stock towers/arms, and flipping it raises the front up from 3.8cm to 4.3cm) ![]() now take the rear clip off the titan and put long screws in the holes then put 3 nuts and screw them to the top on each screw like i did(3 nuts = .5cm) ![]() now screw everything back on then put on your body ![]() ![]() ![]() now for the hummer do the same thing but use 2 nuts on each screw instead of 3). Enjoy ![]()
__________________
Any questions about 1/18 and bigger scale r/c? I'm just one Private Message away Check out my B/S/T Thread Want remixes of some songs... PM me.. I has DJ programing software ![]() Inventor of the idea of using Bob Saget to name R/C parts ٩(-̮̮̃•̃)۶ Last edited by mycrors4; 08-15-2009 at 09:50 PM.. |
#2
|
||||
|
||||
![]() nice but not too much of a lift :-P
__________________
New project: '65 Drag Mustang mods to be made: pro street rims some sort of suspension upgrade (message me if you have suggestions) soft drag slicks Titan: mods to be made: CF driveshaft composite driveshaft gears |
#3
|
||||
|
||||
![]() I'm sure you can adapt with longer screws
|
#4
|
||||
|
||||
![]() 5mm lift is like putting on offroad kit and maybe a little higher
![]() of course you can, i just didnt have any with me ![]()
__________________
Any questions about 1/18 and bigger scale r/c? I'm just one Private Message away Check out my B/S/T Thread Want remixes of some songs... PM me.. I has DJ programing software ![]() Inventor of the idea of using Bob Saget to name R/C parts ٩(-̮̮̃•̃)۶ |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|