![]() |
#1
|
||||
|
||||
![]() Difficulty 4/10
Time: Should take about 15-30mins (Depends on how fast you work) Ok, alot of people have come up with different ways to extend there truck chassi but i found the easiest way (or at least i think it is) to extend your chassis. This will give you anywhere from over a 1/4 inch to almost 1 inch. This tut is for using the f-150 or Nissan Titan Chassi Spacer. To be able to run 4X4 you will need to make or have a custom drive shaft for it. Step #1:Gather your materials Xmods Screw Driver Small Flat Head Screw Driver Needle Nose Pliers (Optional) Your Truck Chassis The body you are using Three 2-56 Steel Locking Nuts Three Long 2-56 Steel Machine Head Screws or Three Medium 2-56 Steel Machine Head Screws ![]() Step #2:Lets Get Started ![]() ![]() Next You Need to remove your Spacer for the gearbox cover on the rear. ![]() Step #3 Pull the Spacer Off once you unscrew the screws. ![]() Now grab Either the Long or Medium Screws (I used Medium) ![]() Take your three Screws and out them in all three holes, then take the three 2-56 Steel Nuts and thread them on the bottom two Screws & the top one, but leave some Space for it to be tightened after being screwed in. ![]() Step #4 Then Line your spacer back up with the rear piece of the chassis you removed at the beggining, Make sure it is straight then Start Screwing it in. ![]() Next do a test Fit, this is were you decide if you need to shorten it some more or Lengthen it (By Tighting & Lossing the Screws). Note:Mine is only about a 1/4 Inch Lengthened. ![]() Step #5 Take the Rear Back off again, and take the needle Nose Pliers and tighten up the 2-56 Steel Nuts, Make sure they arent two tight, you dont want to crack the Plastic. ![]() Then put it back onto the main peice, and screw it back together. ![]() Comments & Concerns & Improvements Welcome
__________________
![]() ![]() TEAM XI
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|