#1
|
|||
|
|||
Hand winding motors.
After reading up some about Hand wount? motors... I thought, why dont I try it,... So I tore? apart a S1 motor, and I was reading about how many winds,
A stock can take around 47 correct? I wanna do 50 winds too be safe? Well, when you say winds... You mean, like that many times around the 3 things... Like, you take the arm outta the can, And keep mags in. and then you get your wire stuff lose, now you have those 3 mag looken things, that keep the wires in place, I wind that 50 times, to each of them correct?? |
#2
|
|||
|
|||
Check this tut out man...
http://xmodsforum.co.uk/showthread.php?t=2194 Are you gunna use it in a gen1 or EVO? Ge1n you shouldn't go any lower than 47T, but at 47t don't gear it over 9 teeth..the fets can go... |
#7
|
|||
|
|||
Quote:
If you use torque gears, I take you'll be drifting. Then you should still use around 40 turns. 37 is the dead limit. |
#9
|
||||
|
||||
Okay well redsxmodder said on xmf that 45 turns is the lowest a stock fet evo chassis so I have been running 50 turns in a can with iso mags from a crest spin brush
__________________
Team ACCENTS Founder Team Ford GT Founder |
#10
|
|||
|
|||
Ok, well I thought 37T was the lowest, maybe I should speak with him...
|
#11
|
||||
|
||||
Well do please let me know what my limits are lol. I want to wind the lowest wind number possible with out blowing my fets. And I run my hand wound motors in evo chassis only
__________________
Team ACCENTS Founder Team Ford GT Founder |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|