Go Back   XmodSource.com > Xmods > XMOD Electronics
Register FAQ Members List Calendar Gallery iTrader Today's Posts

Closed Thread
 
Thread Tools Display Modes
  #1  
Old 03-14-2011, 08:31 PM
Evolution Evolution is offline
Stage 2 member
 
Join Date: Jun 2008
Posts: 62
Trader Rating: (0)
Default

Hey,

So i was doing a mini z board swap with my xmod yesterday and everything seemed to go terribly wrong! I doubled check, and even printed out the instructions on atomic mods, cept I was using a mini z OL board instead of the mr-02. Just as I turned on the car, my servo went berserk. It wouldn't center and just shook really fast back and forth. When I tried to steer, it would just lock onto one side. I don't know what I did wrong. I wired the orange and black wire together from the potentiometer, and connected it to the orange mini z wire, and the white one with the green wire. INstead of using an xmod steering motor, I went with a mini z one. That's the only thing I didn't follow. On my 3rd try, smoke came from one of the steering FETS, and one of the servo motor wires melted off. DID I BLOW A FET TOO? I then soldered it back on, and turned the car on again, and got the same berserk movement. Can anyone tell me where I went wrong, and if my FETS are dead? I'm thinking of either sending it to atomic mods for help, or buy another mini z board, and start at square one.

Nvm, everything's all good. I switched back to old xmod steering motor, works fine now. My first hobbygrade xmod.

Last edited by FloydfanYodaman; 03-15-2011 at 01:46 AM..
Closed Thread


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.