|
#1
|
||||
|
||||
Flip brushes on Atomic Stock R Motor ??
I read that I need to flip the brushes on the Atomic Stock R Motor for it to run correctly in my Evo/Street but then I read that just switching the positive and negative is good enough - what should I do? Thanks.
Use a 2x2 FET stack btw... |
#2
|
||||
|
||||
Quote:
That motor has advanced timing it is necessary to swap the brushes. IT WILL run the other way but reverse will be much faster than forward throttle.
__________________
XMS Approved Service Provider I install FETs and do repairs on Xmods and Mini-Zs including the new 2.4Ghz ASF boards and MR-03s. |
#4
|
||||
|
||||
FETs are my specialty. Be sure to let me know if you need any help. I strongly recommend having some soldering braid on hand and I do NOT use flux on the board, I feel it makes it more difficult. Also, no more than a 15 watt soldering iron.
__________________
XMS Approved Service Provider I install FETs and do repairs on Xmods and Mini-Zs including the new 2.4Ghz ASF boards and MR-03s. |
#5
|
||||
|
||||
Ok thanks again, I do not have any braid right now I think - hmmm might be some in the garage. Yeah I do not like using flux core wire either so I got some regular soldering wire which works great. My smaller iron is about 15w so thats good for SMD devices like these Mosfets. I need to get one of those Weller variable stations - those are nice - have u seen those - I do alot of soldering, since electronics is my hobby, job and life lol.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|