Car wont turn all the way

[SpAnKy GreG]

My Corvett z06 wont turn all the way left.. Anyone can help?

[lol]

Is there a rock obstructing the servo rod thing? Take out your tierod and look under there.

[SpAnKy GreG]

i have i seen the gears that turn it and when i turn on the car and leave it all apart the gears are moving so i turn the weel right and it will go but if i turn left it wont go and the gears will pop out

[lol]

Make sure your front assembly is secured correctly, check for any missing screws and replace them. Especially around the servo area.

[dontspamme]

Check for your stearing trim is in the middle and not pushed aside. Once you have done that, take everything apart, gears out and etc... turn on the car. Let the servo center and pop everything in as carefully as you can and close as the middle as you can. Re-assemble and see if it's any better.

Also, check your servo wires leading onto the board. See if any of them are loose or have even fallen off.

the steering on xmods is very sloppy to begin with. aftermarket parts will greastly help the turning!

[lol]

Originally Posted by dontspamme

Check for your steering* trim is in the middle and not pushed aside.

I think that's the reason, from sharp turning, the tierod can get wedged under the turning notch.

*Typo fix

[taiwanesekid05]

Did you check the back of your remote with the "min" "max" knob turny thingy? If its not turned all the way to the "max" side, it won't turn very well.

[SpAnKy GreG]

Im going to take apart the car today, Hopefully I can fix the problem, I checked the wires and the controller its nun of that..