Difficulty 2/10
Takes about 2-5mins
Ok, well i figured out a quick and easy way to lift a muscle car, to give it a more agressive look on the rear.
Step #1:
Items needed:
Your xmods screw Driver
A small Flat Head Screw Driver
Your Xmod Body
Xmod Rear Clip
Xmod Chassi
2-56 Round Head Machine Screws & 2-56 Machine Steel Nuts
Step #2
Take your Body & Unscrew the Rear Clip
Next take out one of these three 2-56 Round Machine Head Screws
(You can use any length, but i used the middle length one)
Step #3
Take Whatever Screw Length You picked & put the Machine Steel Nut on it and screw it almost all the way down
& if your worried about the nut coming unscrewed put a dap of model glue or hot glue on it, so it makes a temporary hold until you ready to remove it.
Then Start Screwing it down, until you get the Right Height Your Looking For.
(This is when you can test it to see if you like the Height or not)
Here is How Mine Turned Out.
Also One Reason Mine is So high is because i 6 celled it and i need to mount it on the roof of the car, so i can sit it lower. (Im out of Micro Dean Plugs)
All Comments & Tips Apperciated