Quote:
Originally Posted by RodsRUs
I would check make sure the gear ratios are right and definitly check your drive shaft length.
|
It doesn't seem to be anything to do with the driveshaft since it doesn't bind when I try to drive the car in reverse (with the stage 1 motor). The gear ratios are also correct as i have used the stock gear ratio with no luck.
Quote:
Originally Posted by KITT222
Try to make sure that none of the screws are catching where the dogbone enters the knuckle. Mine was acting up as-descibed when I was manually spinning the wheels, and so i disected it, and I was the screw was pretruding into the knuckle. When I turned the car on after I loosened out the screw it was just fine. But I think that one was from the Evo series. The one that I got from the Street series still works just fine.
|
Did your car run in reverse and not forward? It seems like a problem like that would cause the car to not run in any direction.