Ok, more time resulted in this...
http://www.youtube.com/watch?v=h_ZvJCS4itw
-This is a video of the car with the Gen1 PCB and 4x4 kit and lithium with 11tooth gear.... not running on ground
-Workbench....
-Gen1 PCB out....
-Evo PCB with 2x3 stacked fets from my yellow hummer!
-Conections... all good...
-Shrink heat tape on soldered wires...
-The Evo board on the Gen1 chassis.... and it works!!!!!!!!!
Problem is reversed steering... when i checked everything on the servo... it goes to right the horn... but on the car horn to right means tires to left ...
no problem, just switch the remote!:scholar:
http://www.youtube.com/watch?v=NZzloN5YJDM
-And a video of the Evo board connected to the Gen1 car.... it works!!!!!!! Better than the stock.... 2x3 fets give some punch... even with stock motor!