[AeroSynch]

Started to disassemble the Slash today. This is what the center driveline looks like:




Here is the transmission removed with motor. I am surprised at how small it is! It is perfect for a transfer case in my opinion, so I will either use two Slash transmissions, one at the front connected to another one as the transfer case, or just a center mounted transmission.







Then I removed the front axle from the chassis:







I mocked up the LR3 with the axles to see how I was going width wise, and it is perfect. If anything, I might add a bit of spacing. The body will not be as high.











Started toying with the drive line layout: