Ive gotten a start on some of the parts blending:
In the photos below you can see the start of the rear control arms with the knuckle for the axle. Ive taken a Micro-T arm and with a bit of cutting and shaping made a "knuckle" from the MA010 Atomic SAS system.
A ballstud link will make the upper control arm and i just need to get a very tiny drill bit to make a through hole for mounting some hardware. There are screws in the Micro-T kit that have a smooth shaft with a few threads near the screw head that'll do nicely for easy smooth pivot action...
Having some fun.
