Got this in a roller, VINTAGE silver can motor, another servo included. It didn't come with the two rear shocks and the body however. So here a build begins.
First things first, I swapped out the OFNA SX-0001 servo for a TowerPro 995MG. I then installed a XL-1 ESC. It has been plasti-dipped so its basically waterproof. Slapped on a water proof RX Box from Rustler and here it is. I temporarily put Rustler front shocks on the rear, can't bear to see this little guy sagging.
Springs a bit stiff, stock links bend when compressed
Bought Items:
CC-01
Integy 55T Crawler / Lathe motor
Things to buy:
Proper Shocks - looking at GPM
OEM Tamiya Mitsubishi Pajero Body
Better rims and tires later on.
Things to do with the CC-01
Try and crawl and fail miserably.
Go trailing.
the dreaded brick hacksawed away.
FLECKS. FLEX. SHOW OFF TO THE LADIES.
