[TheB1GDude]

Hey all,

Just giving you an update on the current status of my 1/18 scale Losi MRC:

Originally Posted by TheB1GDude

Hey all,

I picked up an MRC a while back in a trade with zippo... this is how it started life:



I've torn it down and rebuilt it so many times, for example:



I was at the point of getting rid of it, I did in fact try to sell it but didn't get any bites so one day last week when I was bored I figured I would take another stab at a scale build using a custom chassis and body I bought from a member on another site a while back...

I'm not yet finished assembling it but this should give you an idea of how it will look:



In terms of my progress... well I have pretty much everything installed and the chassis is basically running. I recently picked up a second PunkRC electronic dig and figured I would setup rear steering on this, the one piece I need is a 4 link servo plate which should be here in the next day or so then once I have that I'll get the rear steer setup and should be ready to crawl.

Here's a few shots of the chassis as it stands:






The electronics end up being tucked away between the body and the panel I added to mount them on. The PunkRC dig sits behind them which isn't ideal as it is exposed to the elements but I'll deal with this when I do the wiring for the rear servo.

The transmission has been flipped which is how the chassis was designed.

The front axle has with aluminum C's, knuckles, lockouts, metal lockers and overdrive gears.

The rear axle has aluminum lock outs and metal lockers.

Tires are 1.55 Mud Thrashes mounted on white steel stamped wheels.

Shocks have internal springs and are in the process of being setup for droop.

Front servo is a Hitec HS-645MG, the rear is the stock MRC servo but I will probably replace both with waterproof servos some point soon.

The motor at the moment is just the stock one but I have a really nice 22T Holmes Hobby motor that I plan on sending in for a rebuild before installing.

Photos aren't the best but once the rear servo is in and the body is mounted I'll come up with a much better set.

Q&C welcome.

Thanks!

Originally Posted by TheB1GDude

Finished setting up my shocks...



I originally had them with just an internal soft spring and a short length of nitro fuel line tubing to control the height but I've since changed them to have soft springs on the outside as well then adjusted the shocks to control the spacing.

Originally Posted by TheB1GDude

Here's a few shots with the body mounted:






I may need to rethink my electronics placement as they interfere a little with how well the body sits, I also need to have a think about final mounting of the body as at the moment there is just a hole cut into the underside of the interior that allows it to rest on the transmissions, that isn't really secure for outdoor use.

Still waiting on my rear servo / 4 link mount, once I have that installed I'll start to finalize the placement of everything.

Originally Posted by TheB1GDude

Started to redo my wiring and component layout...



Still struggling with the battery... don't have the money to go lipo so stick with the original Ni-Mh packs... thinking about maybe fitting it under the hood of the body to add some additional front end weight.

Enjoy.