Quote:
Originally Posted by XMDrifter
you need to buy the front end, rear end, and middle parts of a mini-z and fit them onto your xmod along with the driveshafts and knuckles and a mini-z board and radio and hot mini-z motor llinked to a 2x2 mini-z fet stack and mini-z wheels and tires and mini-z bearings and a mini-z body. then you will keep up with a mini-z in your xmod that has essentially been replaced by a mini-z
|
lololololol i couldn't help but laugh at your list of parts XM hahaha
Another thread about a Z killer..... still hope someone can make one.
But if I had the money, I would say its possible, only with a Gen 1 chassis (very light weight.)
If your car is an Evo though, you will have trouble reducing weight because of the battery tray, rear pod, etc.
All that excess plastic is hard to get rid of on an Evo car but a Gen 1 can be stripped to bare minimum so if you can get it light weight yet stable with some nice electronics from a Mini-Z, it would be able to keep up with one.
Lots of stuff go into a "Z-killer", hopefully you can do it
