i think you should go with a complete lift.
or use lowering top arms with off road a-arms and really long top suspension screws for lots of travel. and make sure to sleeve the screw in something like slippery scotch tape so the suspension doesn't lock up.
think you can probably go back to using stock skirts or no skirts at all
stock hood probably would look more like the bullydog baja truck
black wheels
thick tire mod (c1v1c did a write up)
you can probably use paperclips and solder to make the bars and stuff
you can use bodykit packaging plastic to make the front and rear skid plates
and you can drill out the KC light bar and install CL led's in them (and splice them into the same power source as the regular lights. the foglights can probably be like a cut up KC light bar
the roof rack you can make from paperclips and solder
black out the grille and run 2 batt packs (same battery brand and type please) so that it has the same voltage but much higher mAh (Example: energizers:850 mAh packs x 2 = 1700mAh pack)
connect it black wire to black wire and red to red.
bajas have like, 1-2 feet of suspension travel after the subtraction of travel used to hold the truck up (droop) that means you have to have 1/2-1 inch of usable suspension travel, nw~.
__________________
|