Quote:
Originally Posted by xmodificationer
I might take my micro-t and do this. I can do the swap and everything but how will I get a xmod servo to work with a micro-t? because they are 5 pin
|
2 wires are for the motor, 3 are for the POT.
You don't need to remove the POT wires.
I realized my turning is aight...I still need to get and slap in some 3.3k resistors on the pot.
Then it should turn better.
Also the micro-t board makes a little noise in the actual losi chassis, if you are quiet, you'll hear it.
In my supra it's LOUD!!
Quote:
Originally Posted by bestdragon2001
Thats the whole point he figured out how to do it, he said hes gonna make a tut too.
|
Yup, thanks for reading.