Lowering
 

How do I go about lowering one of these? Do you just cut the springs or heat them up or are there actual kits?

Do you want the chassis lowered or the body? Or Both.:-? The body you need to do some custom work on the front clip and rear clip.:nod: If it is the chassis then you can buy the lowering arms. They can be found here- http://www.xmodsinternational.com/Xm...on-Plates.html

In addition to that, you can replace the long screws in the suspension plates and tie rod with shorter ones. Be careful not to lower it to much, because then you'll rub against the ground causing an extreme decrease in speed.;)

-XMU :)

I guess the body. It looks to high for the chassis.

Here you go then. This should you some Ideas. http://www.xmodsource.com/forum/show...lowering+xmods

-XMU

Please do try searching around a bit before you ask questions. This Q in particular has been asked MANY MANY times.

Check out the tutorials section aswell for some ideas. :)

Later, T.I.M