Motors...SPEC Sheet
 

I figured why not start a thread that members can
enter motor fields so that other know what kinda
motors are out there?

Ill start...

X2 Lightspeed by: Performance Xmods
Pro Edition:

The X-2 series uses the highest quality neodymium magnets

*Silver Wire
*High Speed Winding
*1mm thick "FAT" Comm
*Extra large armature rotor for max torque
*Spiral Armature
*Neodymium Magnets
*Carbon Brushes
*Foam Padding To Keep Motor Safe
*Super Vented ball bearing can
*Pre-Broken Motor
*Tribo Comm Lubed
*18g Motor Plug

Highly Recommended:

-GPM Alloy Parts
-Li-Poly 12C+ 7.4v Power Source
-Full 18 Wire Upgrade
-Bearings
-AWD
**Tribo Comm Drops Required
**Heat Sink Required
**External Turbo / 2x2 FET stack Required

Motor's tops speed is 50 mph @ 7.4v.

RT-1 Modified Motor by: Performance Xmods

FET Stock Motor On Generation 1 & Evo Xmod

Ball-Bearing Can
High Temperature Endbell
High Performance SB Magnets
EGR Motor Epoxy For Best Wind
Special Torque Displacement Armature
Highly Conductive Carbon Brushes

Note: This motor runs very well at 4.8v - 6.0v. We also recommend an 8-9 tooth pinion. .When running this motor above 6.0v, we highly recommend purchasing comm drops to prevent possible damage.

Hyper Torque 180 by: Performance Xmods

Hyper Torque 180 will beat a stage II motor.

Runs On Stock FETs
Low Amp Consumption
Naturally stays cool so you don't need a heat sink
Silver Brushes To Offer Max Torque & Acceleration
Requires extensive chassis modifications for EVO cars.
No modification required for Gen. 1 Xmods.

Note: We recommend running this motor between 4.8v-7.4v with an 8-9 tooth gear ratio.

Radioshack Stock S-1

130 can
Weak armature
Weak magents
26,000 RPM


Radioshack Stock S-2

130 can
Stronger armature
Stronger magnets
30,000 RPM
*Use the supplied heatsink!

SB Hybrid (Spinbrush)

130 can
RS S-2 armature
Neo magnets
RPMs: N/A
*Stacked FETs not required for this motor
*Best run on NIMH batteries @ 800mAh rating
*Must use alloy heatsink to disperse heat!

Stop bringing back old topics, look at the dates, its more than 60 days old! oh and btw the spinbrush is neo-magnets, check whoanelly.com for info on the motor

true SB is not neo torredo made a special version of it "SB super modified" or something like that but the original motor is ferrite.

Cool, but then you might as well just buy Neo mags, how would it be an SB motor, when only the mags come from the toothbrush's motor, and those are replaced with neo's?

well now i know

dont bring back old topics! this is a sticky so i wont close it but noone else reply to this topic plz!